Expamet Masonry Single Piece Joist Hanger 200 X 100mm (SPSH200100)

About this product…

This single piece joist hanger from Expamet is to be built in to masonry – No mechanical fixings required to wall. 3.75×30 square twisted nails to connect joist. Back of hanger must be tight against wall. Joists are to be cut square with a gap not exceeding 6mm from the rear of the hanger. A minimum 675mm of set masonry must be in place over support flange before loads are applied. Joist to be nailled through side gusset using 3.75 x 30mm square twisted nails. The underside of joists should be notched to provide a level surface for plasterboarding.

Features & Benefits